| Facing panel in niche driver's footwell |
| 1. Insert and remove the cover, remove the screws. |
| 2. Turn and pull back the lock, remove the panel. |
| 3. Install the panel in the reverse order. |
| Nut Covers |
| 4. Remove the frame seal, pry the cover to release the latch. |
| 5. When installing the cover, push until it clicks. |
| Cover pillar |
| 6. Remove the door seal, pry up and remove the cover. |
| 7. When reassembling, carefully insert the door seal. |
| The inner door panel |
| 8. See. Subsection 13.11. |
| Rear shelf (sedan) |
| 9. Remove the rear armrest. |
| 10. Remove the two plastic tabs on the front of the tray flange. |
| 11. Pry up the rear shelf and remove the tray. |
| 12. If necessary, you can remove the shelf assembly by undoing the lower seat belt bolt and thread the strap through the hatch shelves. |
| 13. Install a shelf in reverse order. |
| The inner lining of the trunk (sedan) |
| 14. To remove the back cover, remove the seal and post panel up by disconnecting the clips. |
| 15. Flooring trunk mounted plastic clip. Remove the bracket mounting tapes and the ceiling, and then remove the mats. |
| 16. The assembly is performed in reverse order. |
| The inner lining of the trunk (coupe and hatchback) |
| 17. Remove the plastic cap and unscrew 4 screws that secure the rear panel. |
| 18. Flooring trunk is removed as follows. |
| 19. Lift the rear part of the floor. |
 | 20. Hook and remove the latch from the rear of the deck body. |
| 21. The assembly is performed in reverse order. |
| The inner lid panel (sedan) |
| 22. Hook and remove the plastic tabs, remove the panel from the brackets in the rear cover and remove. |
| 23. The assembly is performed in reverse order. |
| The inner lining of the cargo compartment (hatchback) |
 | |
| 24. Hook and remove the plastic tabs, remove the screws. Carefully trim panel forked post puller, pulling latch, hidden under the rear panel (left) and remove the trim panel (pictured right). |
