| Lights (sedan and hatchback) |
| 1. Remove the overhead lights turn signal. |
| 2. Remove the front grille. |
| 3. Disconnect. |
 | 4. Remove the two side screws. |
 | 5. Remove the two rear screws. |
 | 6. Remove the headlamp. |
| 7. Install in the reverse order. Believe reliable fastening of the lower hinge Believe headlights adjusted (refer to. Subsection 14.8). |
| Courtesy light front Indicator |
 | 8. See. Subsection 14.5 (The photo shows the front connector Indicator). |
| Diffuser front winker |
| 9. See. Subpart 14.5. |
| Front fog lights |
| 10. See. Subpart 14.5. |
| Spotlight |
| 11. See. Subpart 14.5. |
| Rear light |
| 12. Remove the bulb holder. |
 | |
| 13. Remove the four screws (left), remove the bracket (pictured right). |
 | 14. Remove the rear light. The unit is attached adhesive sealant. |
| 15. Clean the light clusters and the opening edge of the body from the remains of sealant. |
| 16. Apply sealant to the edge of the unit lights. |
| 17. Install the lamp in reverse order. |
When removing any light appliance disconnect the battery from weight. 
