| The ignition switch and steering lock |
| 1. See Subsection 12.10. |
| A combination of switches on the steering column |
| 2. Remove the steering column covers. |
 | |
| 3. Remove the right switch bracket (left), by submitting themselves by opening the plug (pictured right). |
| 4. The switch is installed in reverse order. |
| Push-button switches in the middle of the front panel |
 | 5. Remove the middle part of the panel. |
| 6. Disconnect from the switch. |
 | 7. Apply the switch forward and remove. |
| 8. The assembly is performed in reverse order. |
| Switch the heater fan |
| 9. Remove the heater control panel
(see. Subsection 5.1.1). |
| 10. Remove the fan control knob. |
| 11. Release the latch (two at the bottom and one at the top) and remove the switch. |
| 12. Set the switch in reverse order. |
| Switches the driver's side |
| 13. These switches include switch drive mirrors, instrument panel lighting, the front fog lamps. |
| 14. Remove the cover from the instrument panel vents. |
| 15. Working under the panel to release the latch and pull the switch. Disconnect the connector. |
| 16. When assembling the insert switch until it clicks. Replace the cover to the dashboard air vents. |
| Power window switch |
| 17. Hook and remove the switch and disconnect the connector. Connector bracket mounted on the inside, so you may need to remove the door panel. |
| 18. Install the door panel, insert the switch until it clicks. |
| Switch drive hatch |
| 19. Beware of wound thin blade screwdriver PHV- tape, hook switch, which is located in the drive housing hatch. |
| 20. Disconnect and remove the switch. |
| 21. The assembly is performed in reverse order. |
| Limit switches signaling ajar door / door courtesy light |
| 22. Open the door. The switch is located on the front of the front door opening. |
| 23. Remove the screws and pull the switch, disconnect the connector. |
| 24. Set the switch in reverse order. Check the installation of the seal. |
When removing any switch disconnect the battery from weight. 
