| 1. Clean the bearing seats on the brake disk 7. |
| 2. Drive bearing outer ring of the brake disc into a smaller inner diameter. |
| 3. Grease the inner bearing and install it on the inner ring in the brake disc. |
| 4. Lubricate sealing ring and drive it to the brake disc. |
| 5. Install the plug 8. |
| 6. Fill the space between the bearings with grease on the brake disc. |
| 7. Install the brake disc 7 on the axis of the hub 11. |
| 8. Grease the external bearing 6 and install it on the axis of the hub 11 to the stop in the brake disk 7. |
| 9. Install washer 5, taking care to lug it got into the groove of the stub axle. |
| 10. Tighten the nut 4 to 20 Nm. |
| 11. Turn a few turns the brake disk for self-aligning bearings. |
| 12. Loosen the nut 4 and then tighten it by turning with the brake disc, in order not jammed bearings. |
| 13. Rotate the brake disc. Once described in the preceding paragraphs adjusting bearing disc should rotate freely and easily. |
| 14. Install toothed washer 3. |
| 15. Install the spring pin 2. |
| 16. Fill the grease half cap 1 Press on it and the axle hub. |
| 17. Install the caliper 16 and the bolts 23 to 65 Nm. |
| 18. Install the brake pads 1 and 2 (see. Fig. Installing the brake pads), while keeping an eye to push the spring 3 is in the upper position and parallel to the end surface of the pad. |
| 19. Install the housing 26 of the cylinder to the caliper 16. |
| 20. Attach the parking brake wire. |
| 21. Bleed brake system. |
