 printable version
Adjusting the gearshift
Before making the adjustment, it is necessary to check the reliability of the switching of gears as follows: - Check that the shift lever at idle is in "neutral"; - All transfer switch. They should be incorporated safely, without jamming. Particular attention is paid to the blocking of a backing; - Engage first gear; - In gear pick clearance leverage switch, which convert light touch gearshift lever slightly to the left;
| Fig. 216. Adjust the gear control: a - the gap between the gear lever and the stop lever in the housing; In - a bolt A - eccentric
|
- A gap (Fig. 216) between the gear lever and the stop lever in the housing should be 1 to 1.5 mm. If adjustment is required, proceed as follows: - To transfer the gear lever to the "neutral";
| Fig. 217. Loose clamp bracket when adjusting
|
- Loosen indicated in Fig. 217 nuts and bolts of a clip (the place indicated by the arrow). After that, pull the shift lever and the lever should move very freely; - Moved accordingly thrust shift lever back and forth and retighten the retaining clip. Again, check the operation of the shift lever, as previously described; - If you need further adjustment, loosen the screw B (see. Fig. 216) and change the position of the eccentric (in the direction indicated by the arrow).
| 
