add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Audi A6 (1997 release)

general info. full specifications. diagnostics. hints. tips. tricks
Audi A6
Home
 
Audi
A6
General Information
Operation of the vehicle
Maintenance
Maintenance intervals
Service vehicles manufactured through 1999, with the use of conventional motor oil
Service vehicles manufactured since 2000, using oil with long life "LongLife Service"
Motor oil
Changing the oil and oil filter
Engine cooling system
Check of level and density of a cooling liquid
Topping up the coolant
Replacing spark plugs
Draining water from the fuel filter of the diesel engine
Replacement of the fuel filter of the diesel engine
Replacing the air filter element
Check the pressure in the crankcase of diesel engines AFB, AKN
Checking the oil in a mechanical transmission
Replacement and check of level of oil in an automatic transmission
Check the front suspension and steering
Check brake fluid level
Checking the front brake pads
Checking the rear brake pads
Check the fluid level in the power steering
Pollen filter
Door hinges
Checking toothed belt
Code and engine number
Lifting the car
Towing
Tire pressure
Engines
Ignition, fuel injection and exhaust of gasoline engines
The power supply system, and preheating the exhaust gases of diesel engines
Lubrication System
Cooling system
Coupling
Transmission
The front wheel drive shafts
Design features four-wheel drive transmission
Suspension
Wheels and tires
Steering
Brakes
Body
Heating and air conditioning
Electrical
Electric schemes
 


Hit Counter by Digits


print page printable version

Check of level and density of a cooling liquid



Expansion tank engine cooling system is located in the engine compartment.
The coolant level can be correctly verified only on the idle engine.
On the cold engine it must be between the MIN and MAX expansion tank on the hot engine level may be slightly above the mark MAX.
To check the density necessary to use a hydrometer.
A significant decrease in the coolant level indicates the likely tightness of seals. In this case, you should immediately contact your dealer Audi.
In the cooling system without opening the coolant level may be reduced if the motor overheats when the coolant boils and out.




« previos page
Engine cooling system
next page »
Topping up the coolant

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.