add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Audi A6 (1997 release)

general info. full specifications. diagnostics. hints. tips. tricks
Audi A6
Home
 
Audi
A6
General Information
Operation of the vehicle
Maintenance
Engines
Ignition, fuel injection and exhaust of gasoline engines
The power supply system, and preheating the exhaust gases of diesel engines
Power system
Preheating
EXHAUST
Overview
Tightening torques of the exhaust system, Nm
Exhaust
Separating center and rear silencers
The correct position of the elements of the exhaust system
Turbocharger
Lubrication System
Cooling system
Coupling
Transmission
The front wheel drive shafts
Design features four-wheel drive transmission
Suspension
Wheels and tires
Steering
Brakes
Body
Heating and air conditioning
Electrical
Electric schemes
 


Hit Counter by Digits


print page printable version

Exhaust



In order to facilitate the next repair unscrewing nuts and bolts that secure the system, lubricate them with high temperature grease Liqui Moly LM-508-ASC.
Before re-installing the exhaust system components, clean them with sandpaper the connection from the remnants of sealant and rust.
Connecting element in front of the exhaust pipe should not be bent more than 10 ?�, since otherwise it may be damaged.
Rear and center mufflers are designed as a single block, but each of them can be replaced individually.
Nuts of fastening clamps tighten evenly until 40 Nm.

Location clamp connecting a reception exhaust pipe and the central silencer
Fig. 5.30. Location clamp connecting a reception exhaust pipe and the central silencer


When connecting a reception exhaust pipe to a central muffler clamp set, positioning it so that the bottom edge of the clamp bolts located at the level of exhaust pipe (Fig. 5.30).




« previos page
Tightening torques of the exhaust system, Nm
next page »
Separating center and rear silencers

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.