add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Audi A6 (1997 release)

general info. full specifications. diagnostics. hints. tips. tricks
Audi A6
Home
 
Audi
A6
General Information
Operation of the vehicle
Maintenance
Engines
Ignition, fuel injection and exhaust of gasoline engines
The power supply system, and preheating the exhaust gases of diesel engines
Lubrication System
Overview
Recommendations for use of motor oils
The oil pan and oil pump gasoline engine 1.8 liters
The oil pan and oil pump petrol engines of 2.4 and 2.8 liters
The oil pan and the oil pump of the diesel engine of 1,9 l
The oil pan and the oil pump of the diesel engine of 2.5 liters
The lower section of the oil pan of the diesel engine of 2.5 liters
Installing the lower section of the oil pallet
The oil pump of the diesel engine of 2.5 liters
Cooling system
Coupling
Transmission
The front wheel drive shafts
Design features four-wheel drive transmission
Suspension
Wheels and tires
Steering
Brakes
Body
Heating and air conditioning
Electrical
Electric schemes
 


Hit Counter by Digits


print page printable version

Installing the lower section of the oil pallet



Made in sequence, return to removal.

NOTE
When installing it is necessary to replace all seals.

On engines with a gasket on the bottom section of the oil pan, check the condition and location of the pads.
Plastic or wooden scraper to remove any remnants of the old gasket mating surface of the upper and lower sections of the oil pan.
With round metal brush, impaled on an electric drill, clean the sealant from the oil pan.

Place the sealant is applied to the gasket surface of the oil pan
Fig. 6.36. Place the sealant is applied to the gasket surface of the oil pan


Apply a bead of sealant D176 404 A2 3 mm in diameter on the surface of the oil pan gasket (Fig. 6.36).
After applying sealant sump must be set for 5 minutes and allow the sealant to harden for 30 minutes. Only then can be poured into the engine motor oil.
Bead of sealant should have a diameter of less than 3 mm, as excess sealant may get into the oil and clog the mesh maslozabornik.
Evenly diagonally Tighten the oil pan.
On engines with a gasket on the bottom section of the oil pan not overtighten, as otherwise deformed oil pan gasket.
On engines where the lower section is mounted on the oil pan sealing, tighten the bolts initially to 5 Nm and then finally to 10 Nm.
Fill in cooling liquid.
Fill the engine with engine oil.




« previos page
The lower section of the oil pan of the diesel engine of 2.5 liters
next page »
The oil pump of the diesel engine of 2.5 liters

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.