 printable version
The oil pump of the diesel engine of 2.5 liters
| Fig. 3.4.1. Location screws engine cover
|
Remove the screws and remove the engine cover (see. Fig. 3.4.1).
| Fig. 6.34. Location screws heater exhaust pipe and additional heater noise insulation
|
Unscrew the heater exhaust pipe and additional heater noise insulation (see. Fig. 6.34).
| Fig. 3.4.2. Location screws bottom mudguard of a motor compartment
|
Remove the screws and remove the two sections of the bottom mudguard of a motor compartment (see. Fig. 3.4.2). On the left front side of the engine compartment, remove the screw fastening the bracket supporting the air-conditioning duct system. Install the front transverse panel in service position.
| Fig. 6.37. Unscrewing bolts radiator fan with viscous coupling
|
Remove the bolt radiator fan with viscous coupling, keeping the axis of rotation of the fan the other wrench (Fig. 6.37). Remove the left and right casings of a gear belt.
| Fig. 6.38. Location housing screws V-ribbed belt
|
Remove the lower section of the oil pan. Remove the oil filler cap.
| Fig. 6.39. The label on the camshaft during installation in the first cylinder in the compression stroke TDC.
|
For pulley bolt, rotate the crankshaft in the direction of working rotation until the marking ?�OT?� (TDC) on the camshaft in the oil filler hole (Fig. 6.39).
| Fig. 6.40. Set screw 3242 (1) to lock the crankshaft
|
Secure crankshaft in this position. To do this, remove the cylinder TDC sensor, and instead tighten the set screw 3242 (Fig. 6.40).
| Fig. 6.41. Location baffle bolts (1) and screw-caps (2)
|
Remove the screw-cap 2 (see. Fig. 6.41), and instead tighten the set screw 3204 fixing the balancer shaft.
| Fig. 6.42. Location bolts sprockets and oil pipes of the oil pump and the balance shaft on the diesel engine of 2,5 l 1 - a bolt of fastening of an asterisk of the oil pump; 2 - a bolt of fastening of an arm of an oil line; 3 - a bolt of fastening of an asterisk balancer shaft; 4 - Hollow bolts oil line
|
Loosen but do not remove the bolt 1 sprocket oil pump (Fig. 6.42). Loosen but do not remove the bolt sprocket balancer shaft (see. Fig. 6.42). Remove banjo bolts 4 securing the oil pump and oil pipe balance shaft and bolt 2 bracket of oil line and remove the oil line. Remove the two screws and remove the discharge oil line. Remove the mounting bolts of the intermediate sprocket and remove it. Remove the bolts and remove the asterisk from the oil pump shaft.
| Fig. 6.43. Location bolts of the oil pump on the diesel engine of 2.5 liters
|
Place the pump in the reverse order of removal, taking into account the following. Before installing, make sure that the set screws 3242 and 3204 are in place. Tighten the bolt of an asterisk of the oil pump.
| 
