add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Chevrolet Lanos (since 2004 of release), Daewoo Lanos (since 1997 of release)

general info. full specifications. diagnostics. hints. tips. tricks
Chevrolet Lanos
Home
 
Chevrolet
Lanos
Device Car
Operating Guidelines
Faults in the way
Maintenance
Engine
Transmission
Chassis
A steering
The brake system
Electrical
Body
Design Features
Possible malfunctions of the body, their causes and remedies
Removing, dismantling and installation of bumpers
Removing and installing radiator grille
Removal and installation of mudguards of wheels and Lockers
Removal and installation of a forward wing
Removal and installation of a lattice box vozduhopritoka
Hood
Removing and installing bonnet
Removal, installation and adjustment of the bonnet and drive
Door
The trunk lid
Manhole cover fuel tank filler pipe
Seats
Removal and installation of facing of a tunnel floor
Restraint System (SRS)
Rear view mirrors
Dashboard
Heater and air conditioning
Interior fittings
Removal and installation of facing of salon
Removal and installation of facing the boot
Windscreen wiper
Replacement of the fixed glass body
Removing and installing the attachment flanges of the battery
Care body
Wheels and tires
Purchase of spare parts
A trip to the STO
Winter car operation
Preparation for technical inspection
Tips novice mechanic
Applications
Diagrams
 


Hit Counter by Digits


print page printable version

Removing and installing bonnet



You will need a key "10".

HELPFUL ADVICE
In order to avoid injury and prevent damage to parts of the car, remove the hood with the assistant.

1. Open the hood and place it on the palm.
2. Remove from the holder on the left edge of the bonnet tube glass windscreen washer.
3. Gripping pliers ...
... 4. disconnect the other three of the tube on the inside panel of the hood.
5. Disconnect the washer from the tee and take her away.
6. If shooting is not to replace the hood, mark its position relative to the loop, for example, by circling the loop along the contour marker.
7. Remove the two screws on the hood to both hinges and remove the hood.
8. Install the hood and all the removed parts in reverse order of removal.




« previos page
Hood
next page »
Removal, installation and adjustment of the bonnet and drive

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.