 printable version
Removing and installing control unit heating and air conditioning
You will need: a screwdriver with a flat blade and Phillips. 1. Disconnect a wire from the plug "minus" of the storage battery. | | 2. wrung out a screw-driver spring clamps on both sides facing the console dashboard lining up ... | 3. ... and at the bottom, remove the cover. |
| | 4. Remove the two screws securing the plug box to install the radio ... | 5. Pull the plug ... from the dashboard, disconnect the plug connector harness, remove from its holder and remove the antenna cable plug. |
| | 6. Remove from the slot dashboard mounting box recorder. | 7. Remove the two screws that secure the instrument panel to the control unit with heating and air conditioning ... |
| | 8. ... three output latch at the top of the block out of engagement with the instrument panel and move the block so far as the length of the wires and rods. | 9. Disconnect from the power harness pads. |
| | 10. wrung out finger clip shell traction control valve air distribution ... | 11. ... unplug heater shell from the body and remove the rod with a thumb throttle lever. |
| | 12. Similarly disconnect the heater from the levers of traction control valves controlling the temperature of the air entering the cabin ... | 13. ... and recirculation. |
14. Remove the control unit with heating and air conditioning, along with rods. If necessary, disconnect the unit from the thrust levers in the same way as it did when you disconnect from the levers of the heater (see. Pp. 11-14). 15. Install the control unit heating and air conditioning and all the removed parts in reverse order of removal.
| 
