REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Matrix (2002 and 2006 model year)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Matrix
		Operation and maintenance of car
		Engine
		Transmission
		Chassis
		Steering Gear
		Brakes
		Onboard electric
			The power supply system
			Charging System
			Sitemy start
				Overview
				Removing and installing starter
				Adjusting the axial clearance pinion
				Checking the pull-in winding traction relay
				Check keeping winding of the traction relay
				Checking the return anchor of the traction relay
				Test idling
				Dismantling, check and assemblage of components starter
			Anti-theft system
			Tables
		Body
		diagrams

printable version

Adjusting the axial clearance pinion

Disconnect the field coil wire from terminal "M" pulling the relay.

Fig. 7.56. Driving adjust the axial clearance of the pinion

Connect the wires from the terminals 12 V battery (via a switch) to the terminals ?�S?� (+) and ?�M?� (-) magnetic switch (Fig. 7.56).

Set the switch to "ON." In this case, the starter pinion gear pops forward until it stops.

ATTENTION

This test must be carried out quickly, no more than 10 seconds, to prevent the coil from burning starter.

Fig. 7.57. Check axial clearance pinion

With the probe measure the axial clearance between the pinion gear and the limiting ring. If the axial clearance does not correspond to the nominal values range, adjust it by installing or removing shims between the traction relay and the starter front bracket (Fig. 7.57).

Nominal backlash: 0,5-2,0 mm.

« previos page
Removing and installing starter

next page »
Checking the pull-in winding traction relay