 printable version
Electronic Alarms
Checking items Check transmitter Check whether the red LED flashes when you press the lock and unlock the doors on the transmitter. If the LED is not flashing, remove the battery and check the voltage. Nominal Voltage - 3 V. If the battery voltage is less than 3, replace the battery. Used lithium battery CR2032 (3 V, 220 mA ?� h). If you replace the battery remote control transmitter does not work, replace it. The method of preservation code
| Fig. 7.37. Dashboard: 1 - central bracket; 2 - facing the instrument cluster; 3 - the center trim panel; 4 - the instrument panel assembly; 5 - ducts; 6 - lower frame; 7 - bottom right trim panel; 8 - hinge cover glove box; 9 - the glovebox; 10 - a cover of the glove compartment; 11 - the side panel trim; 12 - ashtray; 13 - rear ashtray; 14 - covers the steering column; 15 - the center console; 16 - Sidebar switches; 17 - lower left trim panel; 18 - an arm of the lower left panel finishes; 19 - ventilation grille
|
Remove the center trim panel dashboard (see. Fig. 7.37).
A WARNING Do not remove the wire from the negative battery terminal. |
To save the new codes, follow these steps.
| Fig. 10.20. Location receiver (1) of the electronic alarm
|
Activate receiver keyless entry system and change the switch position to save the code of the receiver ?�OFF?� to the ?�SET?� (Fig. 10.20). Secret codes from the transmitter will be stored in the receiver by pressing the lock button or the unlock button on the transmitter door. In the same way, save the codes of the second transmitter. Switch to save the code of the receiver position ?�SET?� to position ?�OFF?�. Set the center trim panel.
| 
