 printable version
Check and replacement of high-voltage spark plug wires
You will need: face head "10" extender knob.
NOTE In the high-voltage spark plug wire marked with a number indicating the cylinder of the engine, the spark which the wire is connected. |
| | 2. Remove the end of the high-voltage wire of 1st cylinder engine from the spark plug ... | 3. ... and from the holder on the cylinder head cover. |
| | 4. Grasp the rubber tip, remove the high-voltage wire of the ignition coil O ... | 5. ... and remove it. |
6. In a similar manner, remove the rest of the high-voltage spark plug wires. |
7. Check the condition of high-voltage wires, the presence of cracks and damage to the insulation, replace the cable. |
8. Use a tester to measure the resistance of each high-voltage wire. If the measured resistance differs from said Table. 10.4, replace the high-voltage wire. |
9. Install the parts in reverse order of removal. |
Table 10.4 Nominal impedance high-voltage wires motor kW
|
