REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Spectra (2004 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Spectra
		Device Car
		Operating Guidelines
		Faults in the way
		Maintenance
		Engine
		Transmission
		Chassis
		A steering
		The brake system
			Design Features
			Possible malfunctions of the brake system, their causes and remedies
			Bleeding brake system hydraulic drive
			The main brake cylinder
				Replace the master cylinder reservoir
				Replacing the brake master cylinder
			Vacuum brake booster
			Replacement of hoses and tubes hydraulic brakes
			Front brake
			Rear brake
			Parking brake
		Electrical
		Body
		Car Care
		Purchase of spare parts
		A trip to the STO
		Winter car operation
		Preparation for technical inspection
		Applications
		Diagrams

printable version

Replacing the brake master cylinder

Experience shows that in many cases the bulkhead cylinder in garage conditions does not lead to the desired result. Therefore, in the event of a fault recommend replacing brake master cylinder assembly.

You will need: the key "10" socket wrench "12", pliers, rubber bulb.

1. Disconnect a wire from the plug ?�-?� the storage battery.

2. Remove the air supply pipe (see. "Removing and installing the air filter").

3. Unscrew the master cylinder reservoir and pump out the brake fluid reservoir.

4. Disconnect the wires from the sensor to the brake fluid level and disconnect hose clutch master cylinder pipe from the tank (see. "Replacement of the master cylinder reservoir?�).

5. Remove the two nuts securing the master cylinder brake pipes, disconnect the piping from the cylinder and move them aside.

HELPFUL ADVICE

Stop the piping in any way possible (for example, wearing their protective caps the ends of the valve to release the air) to prevent leakage of brake fluid.

6. Remove the second nut on the master cylinder to the vacuum amplifier and remove the master cylinder assembly from the tank.

7. Install the parts in reverse order of removal, fill the brake fluid and remove air from the system (see. "Bleeding brake system hydraulic drive").

« previos page
Replace the master cylinder reservoir

next page »
Vacuum brake booster