 printable version
Replacing the sensor signal lamp oil pressure
The sensor signal lamp oil pressure screw in the oil highway the engine block with his right hand (see photo for clarity, remove the inlet pipe). You will need to face head "24". 1. Disconnect a wire from the plug ?�-?� the storage battery. |
2. Disconnect the sensor harness connector. |
| | 3. Loosen the sensor ... | 4. ... and removing the sensor from the engine block, remove it from the vehicle. |
NOTE It looks like taken from the car sensor signal lamp oil pressure. Note the markings on the transmitter housing to the replacement purchase of the same. |
5. Make a rapid check of serviceability of the sensor. Connect it to a conclusion and the body tester probes included in the resistance measurement mode. Note the resistance value of the sensor. |
6. Through a hole in the sensor fitting metal rod or thick wire gently press on the diaphragm. The resistance should increase substantially. If not, the sensor is defective. |
7. Put on the sensor signal lamp oil pressure sealant and install it in reverse order. |
|
