REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 3 (2003 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mazda
	3
		Operation and maintenance of car
		Engine
			General description new engines models L8, LF, L3
			The mechanical part of engines
				Engine Model L8 or LF
				Checking the contents of the CO / CH in the exhaust gas
				Measurement of engine compression
				Verify accessory drive belt
				General information and safety when removing the power unit
				Removal of sealant
				Removal and installation of the power unit
					Removing support ?„–1
					Removing the motor mount and engine mount ?„–4 ?„–4
					Installing the engine mounting bracket ?„–3
					Installing the motor mount and engine mount ?„–4 ?„–4
					Installation support ?„–1
				Check actuator variable valve timing (L3)
				Removal and installation of the actuator variable valve timing (L3)
				Timing chain drive
				Removal and installation of the oil control valve (OCV) (L3)
				Checking the oil control valve (OCV) (L3)
				By operation of the spool valve (OCV) (L3)
				General repair operations on the power unit
				Check the cylinder head
				Assembling the cylinder (the beginning)
				Assembling the cylinder (the end)
				Assembling the cylinder head
				Assembling the valve timing
			Appendix 1
			Annex 2
			Appendix 3
			Engine Z6 - mechanical part
			Lubrication system
			Cooling system
			Intake system
			Fuel system
			Exhaust and Emission
			Ignition system
			Control system
			Tables
		Transmission
		Chassis
		Steering Gear
		Brakes
		Onboard electric
		Body

printable version

Removing the motor mount and engine mount ?„–4 ?„–4

Fig. 2.92. Motor jack

Secure the engine and the gearbox in unit with the main gear, the engine using a jack and an additional device (Fig. 2.92).

Fig. 2.89. The components of the power unit mounting on the car: 1 - engine mount ?„–1; 2 - motor mount ?„–1; 3 - motor mount and motor support ?„–4 ?„–4; 4 - bus connection of the engine to "weight" of the body; 5 - an arm of fastening of the engine ?„–3; 6 - engine, gearbox in unit with the main transfer

Remove special adaptation (see. Fig. 2.89).

Fig. 2.93. Securing the engine and gearbox on the lift

Secure the engine and the gearbox in unit with the main gear using the lift (Fig. 2.93).

Fig. 2.94. Motor mount ?„–4 ?„–4 and support the engine assembly

Remove the motor mount ?„–4 ?„–4 and support the engine assembly (Fig. 2.94).

« previos page
Removing support ?„–1

next page »
Installing the engine mounting bracket ?„–3