add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 3 (2003 release)

general info. full specifications. diagnostics. hints. tips. tricks
Mazda 3
Home
 
Mazda
3
Operation and maintenance of car
Engine
Transmission
Chassis
Steering Gear
Brakes
Onboard electric
Overview
Power supply system
Lighting system
Screen wipers and washer
Immobiliser
Enable / Disable function key reprogramming without the use of a special device (WDS or equivalent)
Removing and installing ignition
The procedure to reprogram the immobilizer
Anti-theft system
Setting code
Cancel code
Switching off anti-theft lock
Electrical Inspections
Tables
Body
 


Hit Counter by Digits


print page printable version

The procedure to reprogram the immobilizer







NOTE
If you still can not reprogram the immobilizer, check the number of working keys.

Replace the key or do the reprogramming procedure with the addition of keys.
To produce a duplicate key or replacing the immobilizer (key and / or a block of PCM), the client must bring all the keys dealer.
This is due to the fact that pre-programmed key ID erased the PCM when re-programming.
You can not rearrange the PCM from another vehicle. Otherwise, the engine will not start.
Do not replace the PCM new to check when troubleshooting. Key ID and the code word to be programmed in the new block, and it can not be used later for other cars, even if you find out that the old unit is OK.
Alarm can not be disabled.
Make sure that all registered keys allow you to start the engine after the reprogramming procedure. Wait at least 5 seconds before using the next key.
When the client does not need to register more than two keys, the following operations can be terminated after the registration of the two keys.




« previos page
Removing and installing ignition
next page »
Anti-theft system

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.