REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 6 (2002 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mazda
	6
		Operation and maintenance of car
		Engine
		Transmission
			Clutch
			Manual Transmission
			Automatic transmission
			Drive Train
				Overview
				The front drive shafts
					Check the clearance in the front hub bearing
					Check the clearance in the front hub bearing
				Removing and installing front wheel hub
				Removing and installing rear wheel hub
				Removing and installing front connecting shaft
				Assembly and disassembly of the connecting shaft
				Removing and installing drive shaft (cars with manual gearbox)
				Removing and installing drive shaft (cars with automatic gearbox)
				Removing and installing drive shaft (cars with manual gearbox)
		Chassis
		Steering Gear
		Brakes
		Onboard electric
		Body

printable version

Check the clearance in the front hub bearing

Remove the hub bolt using special tools.

Fig. 3.101. Part of the housing, which must bend

NOTE

If the guard prevents the removal of the bolt wheel, make the piece, as shown in Figure 3.101, a few light blows with a chisel and bend it back to the steering knuckle.

Install the bolt into the wheel hub, set the washer and nut on the bolt of the hub.

Fig. 3.102. Tightening the wheel nuts: 1 - a bolt of the hub; 2 - wheel nuts; 3 - brass rod; 4 - Washer

Tighten the nuts holding the wheel hub brass rod (Fig. 3.102).

« previos page
Check the clearance in the front hub bearing

next page »
Removing and installing front wheel hub