add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 6 (2002 release)
general info. full specifications. diagnostics. hints. tips. tricks
 Mazda 6
Home
 
Mazda
6
Operation and maintenance of car
Engine
Transmission
Clutch
Manual Transmission
Automatic transmission
Drive Train
Overview
The front drive shafts
Removing and installing front wheel hub
Removing and installing rear wheel hub
Removing and installing front connecting shaft
Assembly and disassembly of the connecting shaft
Removing and installing drive shaft (cars with manual gearbox)
Preliminary check of the drive shaft
Withdrawal
Setting
Removing and installing drive shaft (cars with automatic gearbox)
Removing and installing drive shaft (cars with manual gearbox)
Chassis
Steering Gear
Brakes
Onboard electric
Body
 


Hit Counter by Digits


print page printable version

Setting



Installing the special tool to hold the side gears
Fig. 3.142. Installing the special tool to hold the side gears


Installation on the connecting shaft of the new clip
Fig. 3.143. Installation on the connecting shaft of the new clip


Install new connecting shaft clamp slot upward. Make sure that the diameter of the clamp is not too high (Fig. 3.143).
After installation, measure the outer diameter.
If it differs from the norm, repeat installation using a new clip.
Maximum outer diameter: 31.2 mm.
Insert the drive shaft into the wheel hub.

Installation of the drive shaft
Fig. 3.144. Installation of the drive shaft


Apply gear oil to the oil seal lip (Fig. 3.144).
Insert the drive shaft in the gearbox.
After installation, pull the body of the internal hinge upon themselves to make sure of reliability of fixing the drive shaft.
The installation of the remaining components are in reverse order.




« previos page
Withdrawal		 next page »
Removing and installing drive shaft (cars with automatic gearbox)

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.