 printable version
Setting
Install the dynamic damper, as shown in Figure 3.152. Standard Length: 334,7-340,7 mm. Install the new clamp cover a dynamic damper.
| Fig. 3.153. Pressing the new rotor sensor anti-lock brake system on the drive shaft
|
Install the new rotor sensor anti-lock brake system on the drive shaft and press them it using special devices (Fig. 3.153). Fill the boot (wheel side) with grease.
NOTE Covers and Wheel Side Transmission different. |
ATTENTION Do not touch the grease hands. Apply grease from the tube, do not let pollution into the case. Grease quantity: 90-110 g |
Install the cover without removing the tape, which was wrapped splined shaft during disassembly. Remove the tape.
Align the labels put at removal and set the tripod, using a rod and a hammer (Fig. 3.154). Install new retaining ring, using pliers for removing and installing the retaining rings.
ATTENTION Make sure that the lock ring established in the shaft groove. |
Fill the joint housing and cover (Transmission) with grease. Grease quantity: 195-215 g Refit the hinge. Set the standard length of the drive shaft.
| Fig. 3.155. Bleeding the covers with a screwdriver
|
Let the air out of the case by lifting the edge of the smaller end covers with a screwdriver wrapped with a cloth (Fig. 3.155).
ATTENTION Do not leak grease. Do not damage the covers. |
Make sure that the length of the drive shaft - within limits. Bend the clamp in a direction opposite to the direction of rotation of the drive shaft when the vehicle is moving forward, and, using pliers, tighten the clamp.
| Fig. 3.156. Installing the clamp cover (Transmission)
|
Lock the end of the clip by bending the locking clips (Fig. 3.156).
ATTENTION Securely mount the clamp in the groove. |
Adjust the gap A
A gap: 2.9 mm. Squeeze a small clamp cover from the wheel, using a special device. Check that the gap in
| Fig. 3.158. Reglirovka gap in the boot (wheel side)
|
If the gap is greater in the rules, reduce the gap of a special device and then squeeze the cover. If the gap in less than normal, replace the clamp cover, increase the clearance of a special device and tighten the new case. The gap: 2.4-2.8 mm. Make sure that the collar of the cover does not protrude from the area of the installation clamp cover. If so, replace the clamp cover and re-install. Fill the bag with grease from the repair kit. Adjust the gap in the rotation of adjusting bolt special tool. The gap: 3.2 mm. Make sure that the collar of the cover does not protrude from the area of installation.
| 
