printable version
Replacement or additional registration key
NOTE If there is no additional guidance on the timeslot is not given, executes each operation within 30 seconds after the previous one. |
| Fig. 7.79. If the customer has only one or no active keys
|
1. Make a new key (s) with the defendant. 2. Using key 1, set the ignition switch to ON. A) Follow the warning lights alarm system in the instrument cluster. B) After the indicator lamp will turn off the security system, turn the key to LOCK 1 for 2 in B, remove it from the lock. 3. Repeat step 2 with key 2. 4. Repeat step 2 with key 3. 5. If there is a key 4-8 (existing and / or new), repeat step 2. 1. Make a new key (s) with the defendant, if necessary. 2. Connect the special tool (WDS or equivalent). 3. Using the 1 key, set the ignition switch to ON. Valid key: the alarm system warning lamp lights up, then about 3 sgasnet. The new key: the alarm system warning lamp lights up. Approximately 1 minvyvoditsya diagnostic code B1601 (diagnostic code 15). A. Perform confirmation of access to the security system. B. Select "Remove the ignition key code."
NOTE Do not select any other command from the menu. |
B. Turn 1 to the LOCK position no earlier than 1 second. G. Turn 1 in the ON position no earlier than 1 second. Approximately 1 minvyvoditsya diagnostic code B1213 (diagnostic code 21) D. Make sure that the alarm system warning lamp lights up, then turn the key 1 to LOCK. 1 E. Remove the key from the ignition. 4. Using key 2, turn the ignition switch to the ON position no earlier than 1 second. Control lamp of the alarm system should light (for about 3 seconds). Make sure that the alarm system warning lamp lights up, then turn the key 2 in the LOCK position and remove it from the ignition. 5. Repeat step 4 with key 3. 6. If there is a key 4-8 (existing and / or new), repeat step 5. 7. After re-programming clear diagnostic codes the PCM using a special device (WDS or equivalent).
|