Removal and installation of the block back door

Remove the rear door glass.

Remove the internal handle.

Remove the rear door speaker.

Disconnect the power window motor connector and automatic servo actuator connector lock the door.

Remove the wiring harness from the back door block the back door.

Remove the bolts.

Remove the hook door lock actuator with its unit.

Pull unit back door a little to himself, not allowing the controller window servo snap to it, remove the unit from the door (Fig. 8.27).

Remove the inner cable handle and the door lock button cable from the hole.

If your vehicle is equipped with servo windows, remove the motor and the window regulator with a servo unit door. If the vehicle is not equipped with motorized windows, remove the knob and the window (Fig. 8.28).

Install in the reverse order of removal.