printable version
Adjusting hatch
Close the door glass.
| Fig. 8.60. Measuring the gap between the glass hatch and the body
|
Measure the height of the gap and between the glass panel and the vehicle body (Fig. 8.60). If the height is not correct, loosen the screws and reinstall the panel glass. Gap: a - 0,8-1,2 mm; b - 0 mm. Tighten the screws.
| Fig. 8.61. Checking density of closing the door
|
Insert the card between the seal and the car body. Make sure that the hatch is closed tightly (if you move the map resistance is felt) (fig. 8.61). If the door does not close tightly, again adjust its position.
|