REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 6 (2002 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mazda
	6
		Operation and maintenance of car
		Engine
			General description new engines models L8, LF, L3
			The mechanical part of engines
			Appendix 1
			Annex 2
			Appendix 3
				Control system
				The principle of operation and the appointment of some components of the control system
					Camshaft position sensor (CMP)
					Camshaft position sensor (CKP)
					The regulator of idling (IAC)
					Management duct with varying characteristics (VAD)
					Start-up system with variable characteristics (VIS)
					The control system of mixing the intake air (VTCS)
					Control valve timing change mechanism
					Fuel injection control
					Office off the air conditioning system
					Management of the electric fan
					Controller Area Network (CAN)
					System of onboard diagnostics
				Fault codes
		Transmission
		Chassis
		Steering Gear
		Brakes
		Onboard electric
		Body

printable version

Camshaft position sensor (CMP)

Fig. 2.228. Waveform output camshaft position sensor: 1 - camshaft position sensor; 2 - inlet camshaft; 3 - angle of rotation of the camshaft 30 ?�; 4 - crank angle; 5 - the output of the camshaft position sensor; 6 - engines of LF and L8; 7 - L3 engine

To identify the cylinder camshaft position sensor detects a rotation angle of the camshaft 30 degrees after top dead center of the piston of the first cylinder. Waveform output camshaft position sensor is shown in Figure 2.228.

« previos page
The principle of operation and the appointment of some components of the control system

next page »
Camshaft position sensor (CKP)