REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 6 (2002 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mazda
	6
		Operation and maintenance of car
		Engine
		Transmission
		Chassis
		Steering Gear
		Brakes
		Onboard electric
		Body
			Overview
			Air conditioning and heating
				Air filter
				Block the air conditioning system
				Evaporator
				Expansion Valve
				Capacitor
				Control system
				Air conditioner control unit
				Check heat exchanger
				Removing and installing rear duct
				Removal and installation of the air conditioning system compressor
				Dismantling and assembling freewheel
				Care of the car body

printable version

Removal and installation of the air conditioning system compressor

Disconnect the negative battery cable.

Discharge the refrigerant.

Remove the right mudguard and mud guard.

Loosen the belt tension and remove the belt.

ATTENTION

Contact with moisture or impurities in the cooling circuit of the cooling capacity of the circuit is reduced and abnormal noise is heard. Always stoppered open fittings after removing any elements of the cooling circuit to prevent the ingress of moisture or contaminants into the circuit.

Fig. 8.89. Removing air conditioner compressor: 1 - cooler hose (top); 2 - cooler hose number 4 (vehicles with left-hand steering); 3 - terminal magnetic coupling; 4 - the compressor air conditioning systems

Remove in the order indicated in Figure 8.89.

Install in the reverse order of removal.

Adjust the belt tension.

Perform the operational test conditioning system.

« previos page
Removing and installing rear duct

next page »
Dismantling and assembling freewheel