printable version
Removing and installing front seat belt
ATTENTION Improper handling of the front seat belt (seat belt pre-tensioners) can lead to accidental triggering of the pretensioner isereznoy injury. Side airbag sensor is attached to the bottom of the central rack. When working in the central rack, disconnect the negative cable from the battery or operate carefully to avoid excessive impacts on the bottom of the central rack. Do not dismantle the belt tensioner. Spring tensioner that is unwound when removed its lid, can be wound manually. In this case, the tensioner will not work properly.
|
Turn the ignition switch to LOCK. Disconnect the negative battery cable and wait at least 1 minute. Remove the lower B-pillar trim.
| Fig. 8.62. Removing the connector plate limiter seat belt
|
Using a screwdriver, lift the connector plate limiter seat belt pre-tensioners (Fig. 8.62). Disconnect the connector seat belt pre-tensioners. Remove the cover.
Remove the bolts and screws, then remove the front seat belt (Fig. 8.63). Install in the reverse order of removal. Make sure that the warning light airbag system lights up for about 6 seconds and then goes out. If the alarm lamp airbag system does not work, as described above, the system has a fault. Check the system, using the on-board diagnostics.
|