REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 6 (2002 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mazda
	6
		Operation and maintenance of car
		Engine
		Transmission
		Chassis
		Steering Gear
		Brakes
		Onboard electric
			Overview
			Power supply system
				Accumulator battery
				Generator
					Checking on the vehicle
					Checking the battery charge indicator
					Check current at the generator
					Removing and installing the generator
					Removal and installation of high-voltage wires
				Starter
			Lighting system
			Screen wipers and washer
			Immobiliser
			The central panel and speakers
			The instrument cluster and controls
			Restraint System
		Body

printable version

Removing and installing the generator

ATTENTION

When the battery is connected between the car body and the terminal may occur in the sample. This can lead to injury, fire or damage to the electronic components of the car. Always disconnect the battery before removing the alternator.

Disconnect the negative battery terminal.

Remove the ancillary drive belt.

Remove the front pipe exhaust system.

Remove the intermediate shaft.

Fig. 7.7. Removing the generator: 1 - an arm; 2 - In connector; 3 - terminal of the generator; 4 - generator; 5 - heat-insulating cover

Remove the generator in the sequence shown in Figure 7.7.

Make install in the reverse order of removal.

« previos page
Check current at the generator

next page »
Removal and installation of high-voltage wires