1. Remove the front wheels. |
2. Remove the cross member below the engine compartment. |
3. Remove the bracket gearbox. |
4. Disconnect the connection of the oxygen sensor. |
5. Disconnect the exhaust pipe from the exhaust manifold. |
6. Disconnect draft from the gearbox. |
| 7. Remove the connecting rods from the rod stabilizer bar. |
| 8. Remove the mounting rod stabilizer bar. |
9. Establish a jack under a cross-beam front suspension, remove the four mounting screws and two nuts and lower cross member. |
10. Remove the stabilizer bar from the vehicle. |
11. Check the condition of plugs of fastenings and spherical hinges of connecting rods. Replace worn elements. |
12. Installation is spent upside-down removals. |