add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Golf II, Jetta (from 1983 to 1992, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Volkswagen Golf 2 / Jetta
Home
 
Volkswagen
Golf 2 / Jetta
General Information
Engine
The power supply system
Coupling
Transmission
Refitting
Four-speed transmission
A five-speed manual transmission
The four-speed transmission of type 020
A five-speed transmission of type 020
Automatic transmission
Specifications
Removing and installing transmission
Cable shift
Transmission
Front-wheel Drive
A steering
Suspension
Brakes
Body
Electrical
 


Hit Counter by Digits


print page printable version

Removing and installing transmission



Withdrawal

PERFORMANCE ORDER
1. To disconnect a wire from "the minus" plug of the storage battery.
2. Disconnect the speedometer drive.
3. Run 9, subsection 5.1.
4. Remove the two screws on the upper box to the engine.
5. Remove the side bracket gearbox from the body.
6. Remove the nuts from the bottom of the car rear transmission bracket and remove the bracket.
7. Disconnect the axis and hang them on a wire to the body.
8. Remove the three screws and remove the starter motor starter.
9. Remove the protective plate from the bottom of the car.
10. Remove the three screws hydrodynamic transmission.
11. Set the gear lever in position ?�P?�.
12. Disconnect the cable gear lever.
13. Loosen the bracket screws and remove it.
14. Disconnect the cables pedal "gas" and the throttle, without changing their position.
15. Remove the bracket from the side of the gearbox and remove.
16. Remove the three screws on the bottom support of the gearbox, located near the engine and remove the support.
17. Remove the bottom bolts of fastening of a transmission to the engine.
18. Attach the gearbox using a hoist.
19. Lift slightly and reject the shaft.
20. Disconnect the gearbox from the engine by removing it from mounting pins.
21. Lower the gearbox carefully, while holding the hydrodynamic transmission.

Setting

PERFORMANCE ORDER
1. Installation of the gearbox is carried out in reverse order, with the following.
2. Transmission and gearshift lever must be set in position ?�P?�.
3. Tighten bolts half-line to 45 Nm.
4. Tighten bolts hydrodynamic transmission torque of 30 Nm.
5. Tighten bolts of a transmission to the engine torque 55 Nm.




« previos page
Specifications
next page »
Cable shift

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.