add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Passat B6 (from the year 2004)

general info. full specifications. diagnostics. hints. tips. tricks
Volkswagen Passat B6
Home
 
Volkswagen
Passat B6
Operation and maintenance of car
Engine
Overview
Mechanical (engine capacity of 1.6 liters)
Lubrication system
Cooling system
Fuel Injection System
The mechanical part (petrol engines of 2.0 liters)
Lubrication system
System ohlazhdeiya
Fuel system
Injection system
System of release of gases otrabotavschih
Ignition system
The mechanical part (diesel engines of 2.0 liters)
Lubrication system
Cooling system
Fuel system
Turbocharging turbo running on exhaust
The direct injection diesel
security measures
Removal and installation of a cable connection unit injectors and glow plugs
Removal and installation of injectors
Exhaust
Tables
Transmission
Chassis
Steering Gear
Brakes
Onboard electric
Body
diagrams
 


Hit Counter by Digits


print page printable version

Removal and installation of a cable connection unit injectors and glow plugs



Cable channel pump-Force NOC and glow
Fig. 2.356. Cable channel pump-Force NOC and glow plugs 1 - glow plug; 2 - staples of stainless steel; 3 - a fixing bolt; 4 - adapter ring; 5 - Central plug; 6 - connector 7 - conduit



Withdrawal
Remove the engine cover.

ATTENTION
Installing / removing the cable connection is only possible after loosening / tightening brackets. When removing the cable channel of the staples of data occurs extension brackets also too large a gap may bring to the cable break. This applies to work on the replacement unit injectors, as well as all types of work that do not need to completely disconnect central plug.

NOTE
With piezoelectric injectors dismantling the plug connection must be made only by means of a stripper.

Remove the cylinder head cover.
Disconnect the central connector on the cylinder head.

Setting key on the adapter ring
Fig. 2.357. Setting key on the adapter ring


Set the key on the adapter ring, and turn 90 ?� (1/4 vol.) In the direction of the arrow (Fig. 2.357).

Retaining clip and the central connector
Fig. 2.358. Retaining clip and the central connector



Pull retainer 1 up easily with a screwdriver, and then to the central plug into the 2.

Installing a stripper
Fig. 2.359. Installing a stripper


Install the puller side of the connectors unit injectors and remove them in the direction of the arrow (Fig. 2.359).

Fixing screws glow
Fig. 2.360. Fixing screws glow


Remove the plugs from the glow plug 1. Remove the mounting bolts 2 stainless steel brackets and lift the cable connection (Fig. 2.360).

Setting
Installation is performed in reverse sequence, with the following.
Set the cable connection and tighten the fixing bolts to a torque of 10 Nm.

Retaining bracket
Fig. 2.361. Retaining bracket


Install the central plug through the hole in the module supports, at the same time follow the correct installation of the E-ring (Fig. 2.361).
Install the adapter ring (color "long" label indicates 12 hours).
Set the key on the adapter ring and secure by turning 90 ?� (1/4 vol.) Against the direction of the arrow.

Color label adapter ring
Fig. 2.362. Color label adapter ring



NOTE
After proper installation of the adapter ring color "short" label will indicate the 12 hours.

Place and fix the central connector on the cylinder head (Fig. 2.357).
Install the cylinder head cover.
Install the engine cover.




« previos page
security measures
next page »
Removal and installation of injectors

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.