 printable version
Cooling system
| Fig. 2.329. The components of the cooling system: 1 - a radiator; 2 - O-ring; 3 - coolant hose, the top; 4 - a cover; 5 - plug; 6 - a bolt 5 Nm; 7 - a broad tank; 8 - lower coolant hose; 9 - a bolt 10 Nm; 10 - a bolt 5 Nm; 11 - additional cooling fan; 12 - the main cooling fan; 13 - the plug; 14 - Mount the fan
|
ATTENTION When all installation work, in particular in the engine compartment, because of the tight layout, consider the following. |
Motorways of all kinds (such as fuel, hydraulic absorber, activated carbon, cooling systems, circuit conditioning systems, brake lines, vacuum hoses) and electrical wiring must be routed as they were originally laid. Provide space for all moving or hot components.
NOTE When the engine is warm the cooling system is under pressure. If necessary, the repair work is necessary to relieve the pressure. Hose connections are secured with spring clips. When repairing only use spring clamps. For the installation of spring clamps is recommended to use pliers for spring clamps or pliers for hose clamps. When installing, route the water hoses on pulling them. Make sure that they do not touch other components (observe markings on the fitting and the hose of the radiator). |
Plan for connecting coolant hoses (cars with manual gearbox)
| Fig. 2.330. Wiring coolant hoses 1 - expansion tank; 2 - bypass cover; 3 - radiator; 4 - heat exchanger of the heating system; 5 - cylinder head / cylinder block; 6 - the upper coolant hose; 7 - a radiator; 8 - lower coolant hose; 9 - Engine oil cooler; 10 - the water pump / thermostat; 11 - an additional heater
|
| Fig. 2.331. Wiring coolant hoses 1 - expansion tank; 2 - bypass cover; 3 - radiator; 4 - heat exchanger of the heating system; 5 - transmission oil cooler; 6 - cylinder head / cylinder block; 7 - the upper coolant hose; 8 - Engine oil cooler; 9 - radiator; 10 - lower coolant hose; 11 - the water pump / thermostat; 12 - an additional heater
|
Plan for connecting coolant hoses (vtomobili gearbox DSG)
|
