REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Rio (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Rio
		Instructions
		Engines A3E, A5D
		Greasing system
		Cooling
		Fuel system
		Ignition system
		Coupling
		Transmission
			Manual Transmission
			Automatic transmission F4E-K
				Technical data
				Check of work and adjustment of position of the selector lever
				Testing of teamwork of an automatic transmission and the engine for the motionless car (stall test)
				Testing time delay (Lag test)
				Check the transmission fluid pressure
				Check of level and liquid replacement in an automatic transmission
				The procedure for replacing the liquid in the converter of an automatic transmission
				Leaks of a liquid from an automatic transmission
				Replacement of oil sealing rings
				Removing and installing automatic transmission
				Repair of an automatic transmission
				Radiator cooling automatic transmission fluid
				Valve block
				The case of regulating valves
				Oil pump
				Check the resistance of the sensor, input speed of the turbine wheel
				Check resistance of speed sensor
				Mode switch transmission OD
				Switch range gearbox
				The temperature sensor of an automatic transmission
				Solenoid valves
				The linear solenoid valve
				Lever
				Repair of the selector lever
				Check the mechanism selector lever lock
		Axes and power shafts
		Suspension
		Wheels and tires
		Steering
		Brakes
		Body
		The air conditioning system
		Electrical equipment

Check the resistance of the sensor, input speed of the turbine wheel

PERFORMANCE ORDER

1. Disconnect the negative battery terminal.
2. Lift up the diagnostic connector on the sensor flow meter of air.
3. Remove the air filter.
4. Disconnect the speed sensor input shaft / turbine wheel.
	5. Measure the resistance between terminals 1 and 2 of the connector. Resistance: 300 ~ 400 ohms at 20 ?° C
6. If the resistance is not correct, replace the sensor. Torque: 8-11 N ??? m
7. Install the air filter housing.
8. Establish a diagnostic socket.
9. Attach the wire to the negative terminal of the battery.

« previos page
Oil pump