REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Rio (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Rio
		Instructions
		Engines A3E, A5D
		Greasing system
		Cooling
		Fuel system
		Ignition system
		Coupling
		Transmission
			Manual Transmission
			Automatic transmission F4E-K
				Technical data
				Check of work and adjustment of position of the selector lever
				Testing of teamwork of an automatic transmission and the engine for the motionless car (stall test)
				Testing time delay (Lag test)
				Check the transmission fluid pressure
				Check of level and liquid replacement in an automatic transmission
				The procedure for replacing the liquid in the converter of an automatic transmission
				Leaks of a liquid from an automatic transmission
				Replacement of oil sealing rings
				Removing and installing automatic transmission
				Repair of an automatic transmission
				Radiator cooling automatic transmission fluid
				Valve block
				The case of regulating valves
				Oil pump
				Check the resistance of the sensor, input speed of the turbine wheel
				Check resistance of speed sensor
				Mode switch transmission OD
				Switch range gearbox
				The temperature sensor of an automatic transmission
				Solenoid valves
				The linear solenoid valve
				Lever
				Repair of the selector lever
				Check the mechanism selector lever lock
		Axes and power shafts
		Suspension
		Wheels and tires
		Steering
		Brakes
		Body
		The air conditioning system
		Electrical equipment

printable version

Radiator cooling automatic transmission fluid

Radiator cooling automatic transmission fluid

1 - the output tube of a liquid of an automatic transmission (hotter hose);
2 - connecting bolt;
3 - a washer;
4 - output fluid hose automatic transmission (hotter hose);

5 - inlet tube automatic transmission fluid (colder hose);
6 - the radiator;
7 - Connecting bolt;
8 - a washer.

Withdrawal

PERFORMANCE ORDER

1. Lift the car and fix on support.

2. Remove the seven screws and remove the right mudguard of a motor compartment.

3. Establish under a radiator the pallet for liquid gathering.

4. Disconnect the inlet and outlet hoses, automatic transmission fluid.

5. Remove the inlet and outlet tubes of a liquid of an automatic transmission.

6. Remove the heat sink.

Setting

PERFORMANCE ORDER

1. Install the heat sink.
2. Set the input and output tubes automatic transmission fluid. Torque: 32-47 H
3. Slide the inlet and outlet hoses tube automatic transmission fluid, so that the ends of the hoses have reached fillets on tubes.
	4. Install the hose clamp on the hose in the center of marks and under the corner shown in the figure.
5. Check that the hose clamp does not touch any other parts.
6. Install the right mudguard of a motor compartment and fix seven screws.
7. Lower the car.
8. Check the fluid level in automatic transmission.

« previos page
Repair of an automatic transmission

next page »
Valve block