| Headlights |
| 1. Open the hood |
 | 2. Press the latch and disconnect the connector. |
| 3. Remove the cover by turning counterclockwise. |
| 4. Remove the rubber cover. |
| 5. Remove the bulb holder by pushing on the latch. |
 | 6. Remove the bulb. |
| 7. Keep the new lamp only through a clean cloth, without touching the fingers. |
| 8. Install the new lamp so. the protrusion holder went into the notch in the lamp housing. Put cover side up and attach the connector. |
| Parking light |
| 1. Open the hood |
 | 2. Press the latch and disconnect the connector. |
| 3. Remove the bulb holder by turning counterclockwise. |
| 4. Remove the bulb from the holder. |
| 5. Insert new bulb and install in the reverse order. |
| Turn indicator |
 | 1. Open the hood and unscrew the ceiling Indicator in the upper outer part of it. |
 | 2. Remove the lower hinge and pry carefully remove the bowl from the wing. |
 | 3. Remove the bulb holder by turning counterclockwise. |
 | 4. The lamp is mounted in a holder bayonet. |
 | 5. Install the new bulb in reverse order. When installing, make sure that the projection on the ceiling went into the hole of the body. |
| Winker |
| 1. Move the bowl ahead and disconnect from the wing panel. |
| 2. Remove the bowl, turn the holder counterclockwise. |
| 3. Remove the bulb by pulling out of the holder. |
| 4. Install the new bulb in reverse order. |
| Spotlight |
| 1. Remove the two screws that secure the projector, do not touch the adjustment screws. |
| 2. Take out the spotlight, remove the back cover by turning counterclockwise. |
| 3. Remove the retaining ring and the lamp, unplug the connector. |
| 4. Hold the lamp only through a clean cloth. |
| 5. Insert new bulb, aligning the projections and recesses in the ceiling of. |
| 6. Secure the lamp retaining ring, attach the connector. |
| 7. Screw the lid, set the bowl and tighten the screws. |
| Front fog lights |
| 1. Remove the two screws, do not touch the adjustment screws of the beam. |
| 2. Disconnect the connector, remove the retaining ring and the lamp. |
| 3. Install the lamp in the reverse order. |
| The rear combination lamps |
| 1. Open the trunk lid (cargo compartment). |
| 2. Remove the lever to open the hatch in the back of the patch. |
 | 3. Remove the bulb holder. |
 | 4. The lamps are mounted in the holder bayonet. |
| 5. Replace the bulb and install the bracket in reverse order. On the brake lamp / marker lamp provided mounting boss. |
| Bulb license plate light |
| 1. Remove the two screws and remove the bowl from the back cover. |
| 2. Pull out and remove the bulb. |
| 3. Install the new bulb in reverse order. |
