 printable version
Setting
Put on the drive shaft of a small clamp protective cover and protective cover. Replace the shaft joint housing. Install the drive shaft sleeve with the rollers and secure with the retaining ring. Put 80 g of greasing G 000 605 to clip the outside of the hinge and reinstall the hinge case.
| Fig. 10.11. Location of the locking ring (1), the cover (2) and the sealing ring (3) in the end of the drive shaft holder hinge
|
Set at the end of the yoke O-ring, cover and retaining ring (Fig. 10.11).
| Fig. 10.8. The use of special tools for mounting clamp A - screw tightening tool sponges; The - setting instrument on the clamp jaws
|
Install a protective cover on the hinge, laying in a lubricant, and secure it with clamps previously raised inner edge of the cover with a screwdriver to equalize the air pressure under the cover. To use the tool mounting clamps 1683 (see. Fig. 10.8). Sponge tool set at the corners Clamp and in this position squeeze the sponge screw tightened its moment of 20 Nm.
| 
