 printable version
ECU E87
Before removing the ECU E87, check for errors in recorded memory. After replacing the ECU E87 enter the new code block and nullify the error recorded in the memory unit. E87 If the air conditioner continues to operate after the ignition is switched off, check the electrical circuit pin 1, connector D (the connection of additional heater). If you replace the control unit display unit will flash for 2 minutes after the ignition is switched on, enter your code block and nullify the error recorded in the memory unit. If there is no illumination of the control unit E87 after ignition, check the voltage at the terminals 58d dimmer.
Withdrawal Vehicles without navigation system Remove the radio. Remove the front section of the center console.
| Fig. 17.7. Arrangement of screws (1) securing the display unit (2)
|
After loosening the screws of the lower blade screwdriver 1 leaned forward and remove the clips before disconnecting the electrical connectors of the display unit. Remove the display unit 2.
Vehicles with a navigation system Remove the navigation system.
| Fig. 17.8. Arrangement of screws (1), clips (2) and clamps (3) of the display unit (4)
|
Lift the display unit 4 and remove it in the direction of the arrow shown in Fig. 17.8.
All models
| Fig. 17.9. Location clamps (1) for electrical connectors (2)
|
Press catches 1 (Fig. 17.9) and disconnect the unit from the electrical connectors 2. (4)
Setting Installation is spent to sequences, return to removal, taking into account the following. Connect a wire of "weight" to the battery. Turn on the radio and enter the code. Lift up the power window glass until it stops. Then click on all window switches again for at least 1, in the closed position of the control unit to activate windows. Set the clock.
| 
