add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Audi A6 (1997 release)

general info. full specifications. diagnostics. hints. tips. tricks
Audi A6
Home
 
Audi
A6
General Information
Operation of the vehicle
Maintenance
Engines
Ignition, fuel injection and exhaust of gasoline engines
The power supply system, and preheating the exhaust gases of diesel engines
Lubrication System
Cooling system
Coupling
Transmission
The front wheel drive shafts
Design features four-wheel drive transmission
Suspension
Wheels and tires
Steering
Brakes
Body
Overview
The front panel with a transverse auxiliary elements
Front fender
Hood
Grille
A cable of opening the bonnet
Front bumper
Shock Absorber
Rear bumper
The trunk lid
The hinge lid
The front door and its elements
The back door and its elements
The windscreen and rear window
Glovebox
Interior rearview mirror
The center console
The front section of the center console
Cigarette lighter
Dashboard
Carpet covering
Elements of interior upholstery
Heating and air conditioning
Electrical
Electric schemes
 


Hit Counter by Digits


print page printable version

Front fender



Front fender
Fig. 16.9. Front wing: 1 - the front wing; 2, 3, 4, 5, 8 - bolts 10 Nm; 6 - bolt 15 Nm; 7 - an arm


Front wing and its fastening elements are shown in Fig. 16.9.

Withdrawal
Remove the front bumper.
Remove the front wheel.
Remove the screws and remove the facing of a niche of a forward wheel.

Cover plate inner rear part of the front wing
Fig. 16.10. Cover plate inner rear part of the front wing: 1 - screws; 2 - a protective cover; 3 - piston spacer; 4 - front wing


Remove the screws and remove the cover plate inside of the back of the front wing (Fig. 16.10).
Remove the headlamp.
Disconnect the electrical connector from the side repeater turn.
Remove the bolts 2, 3, 4, 5, 6, 8 (see. Fig. 16.9) securing the front wing. Bolts coating protects the tool, and unscrewing is necessary to use new bolts.

Setting
Installation is spent to sequences, return to removal, taking into account the following.
Set the front wing on the car, align the bolt holes and tighten the screws 2, 3, 4, 5, 8 (see. Fig. 16.9) to 10 N ?� m, and the bolt 6 - 15 N ?� m. When installing the wing, make sure that the gaps between the fenders and hood, as well as between the wing and the front door were uniform over the entire length and is 3.0 ?� 1.0 mm.




« previos page
The bottom mudguard of a motor compartment
next page »
Hood

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.