add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Chevrolet Lanos (since 2004 of release), Daewoo Lanos (since 1997 of release)

general info. full specifications. diagnostics. hints. tips. tricks
Chevrolet Lanos
Home
 
Chevrolet
Lanos
Device Car
Operating Guidelines
Faults in the way
Maintenance
Engine
Transmission
Chassis
A steering
The brake system
Electrical
Body
Design Features
Possible malfunctions of the body, their causes and remedies
Removing, dismantling and installation of bumpers
Removing and installing radiator grille
Removal and installation of mudguards of wheels and Lockers
Removal and installation of a forward wing
Removal and installation of a lattice box vozduhopritoka
Hood
Door
Removing and installing front door trim
Replacing the glass front door
Replacing the front window
Replacing the outside handle of the front door
Replacement of the internal handle of the front door lock actuator
Replacing the front door lock switch
Replacing the front door lock
Replacing the terminator of opening the front door
Removing and installing front door
Removal and installation of an upholstery of a back door
Replacement glass back door
Replace the rear door window
Replacing the outer rear door handles
Replacement of the internal handle of the rear door lock actuator
Replacement lock the back door
Replace the rear door opening limiter
Removing and installing rear door
The trunk lid
Manhole cover fuel tank filler pipe
Seats
Removal and installation of facing of a tunnel floor
Restraint System (SRS)
Rear view mirrors
Dashboard
Heater and air conditioning
Interior fittings
Removal and installation of facing of salon
Removal and installation of facing the boot
Windscreen wiper
Replacement of the fixed glass body
Removing and installing the attachment flanges of the battery
Care body
Wheels and tires
Purchase of spare parts
A trip to the STO
Winter car operation
Preparation for technical inspection
Tips novice mechanic
Applications
Diagrams
 


Hit Counter by Digits


print page printable version

Removal and installation of an upholstery of a back door



You will need: Phillips screwdriver and flat blades.
1. Having hooked a screw-driver, remove the lining of the internal handle lock.

HELPFUL ADVICE
In order to avoid scratching the components, wrap the screwdriver with insulating tape.

2. Remove the screw that secures the socket lining in the arm of the door ...
3. ... and remove the trim.
4. Press the door trim to the socket window handle ...
5. ... through the resulting gap, remove the spring clamp handle by prying with a screwdriver ...
6. ... and remove the handle window and its socket.
7. Remove the trim angle of the back door against the force of its two spring clips.
8. Remove the two screws securing the trim to the bottom edge of the door.
9. Having hooked a screw-driver upholstery in locations of its plastic caps ...

NOTE
Upholstery (view from the back side) is attached to the door panel with five plastic pistons. Damaged replace with new pistons, removing them from the brackets upholstery.
If necessary, remove the upholstery foam sealing ring and roller window.


10. ... release the cover panel on the door against the force of the pistons.
11. Remove the two screws that secure the bracket to the armrest of the door panel and remove the bracket.
12. Peel off the door panel moisture proof film.
13. Install the rear door trim and all the removed parts in reverse order of removal.

NOTE
Installation bracket armrest arrow stamped on it must be facing forward in the direction of travel.




« previos page
Removing and installing front door
next page »
Replacement glass back door

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.