add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Chevrolet Lanos (since 2004 of release), Daewoo Lanos (since 1997 of release)

general info. full specifications. diagnostics. hints. tips. tricks
Chevrolet Lanos
Home
 
Chevrolet
Lanos
Device Car
Operating Guidelines
Faults in the way
Maintenance
Engine
Transmission
Chassis
A steering
The brake system
Electrical
Body
Design Features
Possible malfunctions of the body, their causes and remedies
Removing, dismantling and installation of bumpers
Removing and installing radiator grille
Removal and installation of mudguards of wheels and Lockers
Removal and installation of a forward wing
Removal and installation of a lattice box vozduhopritoka
Hood
Door
The trunk lid
Replace lid torsion bars
Removing and installing rear lid
Replacement of locks, latches, and trunk lid lock switch
Removing and installing drive tailgate lock
Removing and installing trim strip boot lid
Manhole cover fuel tank filler pipe
Seats
Removal and installation of facing of a tunnel floor
Restraint System (SRS)
Rear view mirrors
Dashboard
Heater and air conditioning
Interior fittings
Removal and installation of facing of salon
Removal and installation of facing the boot
Windscreen wiper
Replacement of the fixed glass body
Removing and installing the attachment flanges of the battery
Care body
Wheels and tires
Purchase of spare parts
A trip to the STO
Winter car operation
Preparation for technical inspection
Tips novice mechanic
Applications
Diagrams
 


Hit Counter by Digits


print page printable version

Removing and installing drive tailgate lock



You will need a key "10" (convenient to use face head).
1. Disconnect the cable from the tailgate lock, removing the lock from the rear end panel of the body (see. "Replacement of locks, latches, and trunk lid lock switch").
2. Remove the front and rear facing left the floor threshold (see. "Removal and installation of facing of salon").
3. Remove the arch facing the left rear wheel and the left rear light (see. "Removal and installation of facing the boot").

NOTE
End panel lining was removed in the process of removing the tailgate lock (see. P. 1).

4. Turn out through a window in the floor mat bolt unit handles.
5. Bend the edge of the mat and pull the rug from under the unit handle with Bowden cable, extending the unit through a window in the floor cross member.
6. Remove the bracket from the slot unit levers tip sheath lock actuator trunk and removing the cable end of the lever slot, disconnect the cable.

NOTE
If necessary, disconnect the unit is similar to the arms control cable lock hatch of a bulk pipe of a fuel tank (white tip) and remove the unit handles.

7. Remove the cover of a cable from the holder on the left verge of the floor and remove the drive cable lock the trunk, pulling him into the trunk through the hole in the wall of the body.
8. Set the drive lock the trunk and all the removed parts in reverse order of removal. If necessary, adjust the drive (see. P. 7 sub-section "Replacement of locks, latches, and trunk lid lock switch").




« previos page
Replacement of locks, latches, and trunk lid lock switch
next page »
Removing and installing trim strip boot lid

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.