printable version
Sound signal
Refitting Open the bonnet and remove the bonnet lining, removing the two mounting screws.
| Fig. 7.55. Pin audio signal
|
Installation is carried out in reverse order.
Checking the technical condition and adjustment Check the operation of the audio signal by applying the battery voltage to output - should trigger a beep. If it does not, replace the buzzer. If the power of the sound signal becomes smaller or wheezing appeared to adjust signal by turning the screw located on the housing in one direction or another to produce a loud and clear sound.
| Fig. 7.56. Adjusting the sound
|
Turn beep sound and have the right adjusting screw (Fig. 7.56).
NOTE After adjustment Tighten the adjusting screw, which put on a little paint. |
|