 printable version
Device combination
| Fig. 1.24. Controls vehicle Hyundai Matrix: 1 - coolant temperature; 2 - tachometer; 3 - speedometer; 4 - electronic clock; 5 - odometer (odometer) / counter "daily" run / trip computer (optional); 6 - fuel gauge; 7 - control indicator lamps; 8 - a control lamp position selector automatic transmission (only for models with automatic transmission); 9 - MIL immobilizer (optional); 10 - MIL Supplemental Restraint System (SRS) (optional); 11 - a control lamp traction control (traction control) (optional); 12 - a control lamp off raising transfer (only for models with automatic transmission); 13 - a control lamp of inclusion of the parking brake / emergency brake fluid level; 14 - a control lamp of the discharge of the battery; 15 - a control lamp of a reserve of fuel; 16 - a control lamp of inclusion of a headlight of headlights; 17 - a control lamp signaling the back door ajar; 18 - a control lamp signaling door closure; 19 - a control lamp of pressure of oil; 20 - MIL engine (mil) (optional); 21 - MIL-lock braking system (abs) (optional)
|
Instrument cluster vehicle Hyundai Matrix is shown in Fig. 1.24.
Buzzer alarm sound when you turn on the rear fog light (optional) Buzzer alarm sound when you turn on the rear fog light is activated when the rear fog lights are lit and open the driver's door.
The fuel gauge
The arrow of the pointer indicates the approximate level of fuel in the fuel tank.
Coolant temperature
ATTENTION Do not open the radiator cap when the engine is hot. The cooling system is under pressure, and opening the tube can lead to release a hot fluid which may cause severe burns. Wait for the engine to cool before opening the radiator cap. The arrow of the pointer must be within normal limits. If the arrow pointer while the engine is entered into the "H" ("hot") scale, immediately stop the vehicle and shut off the engine. Open the hood and check the coolant level in the expansion tank, and a drive belt the coolant pump.
|
Speedometer
The speedometer shows the current speed.
NOTE The operation affects the speedometer size tires mounted on the vehicle. If the tire size (diameter, but not width) changed compared with the tires installed at the factory, contact an approved dealer to reprogram the engine control system. It is recommended to contact an authorized service station Hyundai. If you do not produce the reprogramming, the speedometer will show the wrong speed. |
Tachometer Models with a petrol engine.
The tachometer shows the engine speed of the engine in revolutions per minute (vol. / Min). Tachometer helps to choose a more economical mode of driving, but also warns that the speed is the crankshaft of the engine exceeds the maximum value.
ATTENTION During movement watch tachometer readings. His arrow indicating the speed of the crankshaft of the engine must not enter the red zone (zone exceeded the maximum allowed speed). |
Odometer (trip meter) / counter "daily" runs
The digital odometer / counter "daily" runs. When you press the reset button (reset) when the ignition key is turned to the ?�ON?� (?�On."), The display will alternate in the following order. Odometer (odometer).
The odometer shows the total distance in kilometers or miles traveled by car, and very easy to control the intervals of periodic maintenance. Counter "daily" runs. Counter "daily" runs shows the distance in miles or kilometers traveled for two trips. TRIP A (run A) running from the start of a trip to an intermediate point. TRIP B (running in) running from the intermediate point to the end of the trip. Pressing the reset button (reset) allows you to switch TRIP A (run A) TRIP B (run in). To reset the counter, press the reset button (reset).
Trip Computer (optional)
| Fig. 1.32. The display trip computer the remaining fuel in the tank
|
Trip computer - an electronic device on the LCD display trip information - odometer, average speed, and estimated mileage on the fuel remaining in the tank.
The reset button (reset) Information on the multifunction display is reset by pressing the reset button (reset).
At the same time there is a change of display screens (see. Fig. 1.31).
Traveled on the remaining fuel in the tank This mode shows the estimated mileage on the fuel remaining in the tank. When topping up more than 6 ltopliva tank trip computer determines refueling. After installing or connecting the battery mileage information on the remaining fuel in the tank will be determined after the vehicle will travel 32 km.
| Fig. 1.33. The display trip computer on the average vehicle speed
|
NOTE Information about the mileage on the fuel remaining in the tank may differ from the actual path due to changes in the conditions of the trip. In addition, the information may vary due to changes in travel conditions, driving style and speed of travel. |
| Fig. 1.34. The display time of the trip computer trip
|
average speed This mode shows the average speed since the last reset time of the trip. When you press the reset button (reset) as a display medium speed for 1 s average speed is reset to 0.
Time travel This mode shows total trip time since the last reset time of the trip. When you press the reset button (reset) as a display of travel times for 1 second resets the trip time to 0.  The MIL Supplemental Restraint System (SRS) (SRI) (optional). This warning light (SRI) lights up and flashes for about 6 seconds after the ignition key is turned to position ?�ON?� (?�On.") Or after the engine is started, then goes out. This warning lamp also lights up in case of malfunction of additional system of passive safety (SRS). If the warning light (SRI) does not light up or continues to constantly lit after blinking for approximately 6 seconds after the ignition key is turned to position ?�ON?� (?�On."), Or lights up while driving, give the car dealer Hyundai to check an additional system passive safety (SRS).  The MIL-lock brake system (ABS) (SRI) (optional). After turning the ignition switch ?�ON?� (?�On.") Illuminates the MIL-lock brake system (ABS SRI) and then goes out after a few seconds. If this light remains on, comes on while driving, or does not light up after the ignition key is turned to position ?�ON?� (?�On."), This indicates a fault in the anti-lock brake system (ABS). If this happens, as soon as possible to appeal to the Hyundai dealer to check the car. The standard braking system will continue to work, but without the aid of anti-lock brake system (ABS).
ATTENTION If the MIL-lock brake system (ABS SRI) and the indicator lamp parking brake / emergency brake fluid level continues to burn after engine start or comes on while driving, there may be a fault of the system EBD (electronic brake force distribution). If this happens, avoid sharp braking and as soon as possible contact an authorized dealer to check the car Hyundai. |
 The warning lamp off raising transfer (optional). When turned on overdrive, the control lamp off overdrive repaid. When you turn off overdrive this lamp lights up red.
 Control indicator lamps. On the instrument panel flashes a green arrow indicating the direction of rotation. If the arrow comes on but does not blink, blink too frequently or does not blink at all, it indicates a fault in the circuit direction indicators.
 The control lamp of inclusion of headlights. This warning light illuminates when the headlight of headlights or flashing headlights is carried out.
 Oil pressure warning lamp. Movement at a low engine oil or burning oil pressure warning lamp may cause damage to the engine (scuffing, seizure, etc.). If this lamp comes on when the engine is running, then the engine oil pressure is below the minimum permissible value. In good condition, this lamp lights up when you turn the key in the ignition switch ?�ON?� (?�On.") And goes out after starting the engine. If the light remains on after the engine is started, there is a serious engine fault. In this case, immediately stop the vehicle in a safe location, shut off the engine and check the engine oil level. If the oil level is below the minimum allowable value, add oil to the engine to a normal level and start the engine again. If the light stays on after the engine starts, turn it off immediately.
 Control lamp of parking brake / emergency brake fluid level. The warning lights. Control lamp of parking brake / emergency brake fluid level should light up when the parking brake and turn the ignition switch to ?�ON?� (?�On.") Or the ?�START?� (?�starter"). After starting the engine the lamp should go out when you turn off the parking brake. When the parking brake is off, the control lamp of parking brake / emergency brake fluid level should light up when the ignition key is in position ?�ON?� (?�On.") Or the ?�START?� (?�starter") and off after the engine starts. If this lamp illuminates at any other time, it is necessary to reduce vehicle speed and fully to stop on the roadside in a safe place. Brake System Warning Light indicates that the brake fluid level in the reservoir hydraulic brakes falls below the minimum level and the need to top up the brake fluid DOT3 or DOT4. If there are any malfunctions of brake system, the movement of a car is unacceptable. The car is equipped with dual-diagonal braking system. This means that even in the event of damage to one of the brake circuits can be used for braking two wheels. In this case, to stop the car to spend more effort on the brake pedal and a larger brake pedal. Moreover, stopping distances will be increased. In the event of failure of one of the brake circuits include a lower gear to use the engine brake to stop the vehicle.
 The warning lamp battery discharge. This lamp lights up when the ignition key is in the ?�ON?� (?�On") and goes out after starting the engine. If the warning lamp stays on after the engine starts, in the charging system has a fault. If the warning light comes on while driving, stop the vehicle immediately and take a look under the hood. First, make sure the integrity of the alternator drive belt, if it is intact, check its tension.
ATTENTION The weakening of the alternator drive belt or a break while driving can lead to serious engine trouble. The motor may be overheated, since the belt also drives the coolant pump of the engine. |
 The warning lamp on the alarm rear door ajar. This lamp remains lit until the rear door is not completely closed.
 The warning lamp signaling door closure. This light warns that one of the side doors of the vehicle is not closed.
 The control lamp of a reserve of fuel. This lamp lights when the fuel level in the tank reaches the minimum reserve value. If the lamp is lit, it indicates the need for refueling. The movement of the vehicle at a burning control lamp of a reserve of fuel or if the fuel level is below the "E" ("empty") can lead to misfire and damage the catalytic converter.
 Engine warning light (MIL) (optional). This lamp lights up when a fault is detected components (parts), relating to the systems of decrease in toxicity. It also illuminates when the ignition key is turned to ?�ON?� (?�On.") And then, after a few seconds, it should go (only on models with engine capacity of 1.5 / 1.6 liters. ). This lamp lights up when the ignition key is turned to ?�ON?� (?�On.") And then goes out after starting the engine (only on models with engine capacity of 1.8 liters.). If the lamp lights while driving, or does not light up after the ignition key is turned to position ?�ON?� (?�On."), Give the car the nearest official dealer Hyundai to check systems.
 The indicator lamp traction control (TCL) (optional). This warning lamp lights up in accordance with the position of the ignition switch and indicates that the system is working. The lamp lights up when the ignition key is turned to position ?�ON?� (?�On.") And goes out after a few seconds.
Buzzer sound alarm (optional) Buzzer sound alarm is activated when the burning tail lights and open the driver's door. This is to prevent discharge of the battery when the car is left with the burning tail lights. This buzzer will work as long as there will not be deactivated taillights.
Buzzer warning of the parking brake (optional) If the car is moving faster than 10 km / h for 2-3 and with the parking brake warning buzzer is constantly working.
Buzzer, signaling the wear of the brake pads Brake pads front disc brakes have wear indicators, which emit a high squealing sound with full pads wear, indicating the need to replace the front brake pads. While driving the car the sound may come and go or be constant. It can also be heard at stronger pressure on the brake pedal. In the case of driving with worn brake pads can damage the brake disc.
| 
