printable version
Passive safety systems
Adjustable fastening shoulder belts of the front seats
The height of the seat belt front seat can be adjusted to one of four positions. If the seat belt anchor will be located too close to the neck, the belt will not provide maximum protection. The shoulder portion of the belt should be adjusted so that it passes across the chest and the middle of the shoulder to the door neighbor. to adjust the height of the fixing belt, press the lock button on the height of the seat belt and move up or down fastening a seat belt in the desired position, which provides a close contact with the shoulder strap. To lock the seat belt anchor release the lock button. Then try to move the belt anchor up or down to make sure that it is securely fixed in position.
ATTENTION Fastening the seat belt should be fixed at the time of travel. Incorrect height adjustment of the seat belt can greatly reduce its effectiveness in an accident. |
Three-point seat belt driver with clamping and locking mechanisms inertial To fasten your seat belt, pull it out of the retractor and insert the belt strap (latch plate) in his castle until it clicks. Safety belt automatically selects a desired length only after the lap belt is adjusted. Make sure that the belt is properly fastened and not twisted.
Adjustable belt
| Fig. 1.118. The correct position of wearing seat belts
|
Never wear the lap belt across the abdomen. In the event of an accident the belt can dramatically cut into the abdomen and increase the risk of injury. When the belt is too high, it increases the risk that a passenger will slide out from under the belt in the event of a traffic accident (crash) or when braking. This can result in death or serious injury. Both hands must not simultaneously be over or under the belt. One hand has to be under and the other above the belt, as shown 1.118. Never put your seat belt on hand, closer to the door.
Releasing the seatbelt
For Releasing the seatbelt, grasp the bar (latch plate) and press the button on the buckle. When the belt is unfastened, it will automatically ubiretsya back into the retractor. If not, check the belt for looping and try again.
Seat belt at two points (center rear seat belt)
To fasten your seat belt at two points, insert the latch plate in the lock. Fixing the castle accompanied by a distinctive click. Check for loose belt buckle and make sure the belt is not twisted.
Adjusting the rear seat belt
When using the safety belt at two points, adjust its length so that it is tight fitting. Fasten your seat belt and gently pull it to remove any slack. The belt should be positioned as low as possible on the hips. The high location of the belt increases the risk of injury in the event of a traffic accident (crash).
Releasing the rear seat belt
For Releasing the seatbelt, grasp the bar (latch plate) and press the button on the buckle.
ATTENTION Belt fastening mechanism of the central rear seat belt is different from the mechanisms of shoulder belts rear seat. During fastening shoulder straps and the waist of the central rear seat belt, make sure to use the right lock for maximum protection. |
|