REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Santa FE (2006 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Santa FE
		Operation and maintenance of car
		Engine
		Transmission
		Chassis
		Steering Gear
		Brakes
		Onboard electric
			Overview
			Ignition system
				Overview
				Ignition coil (with built-in power transistor - Engine 2.4L I4)
				Removal, check and installation of the ignition
				Ignition system (V6)
				Ignition coil (engine 2.7L V6)
			Charging System
			Engine Starting System
			Tables
		Body
		diagrams

printable version

Ignition coil (with built-in power transistor - Engine 2.4L I4)

Fig. 7.2. The components of the ignition control system

Measuring the resistance of the primary winding of the ignition coil

Fig. 7.3. Measuring the resistance of the primary winding of the ignition coil

Connect the wire from the negative (-) terminals of the power supply voltage of 3 V to terminal 2 of the ignition coil. Then, check the condition of the circuit terminals 1 and 2 of the ignition coil when disconnected and connected from the terminal 3 of the ignition coil wire is positive (+) terminals of the power supply (Fig. 7.3).

Measuring the resistance of the secondary winding of the ignition coil

Fig. 7.4. Measuring the resistance of the secondary winding of the ignition coil

Measure the resistance between the high voltage output and a spark plug wire to the ignition coil (Fig. 7.4).

Standard value: approximately 12.1 ohms.

« previos page
Overview

next page »
Removal, check and installation of the ignition