add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Santa FE (2006 release)

general info. full specifications. diagnostics. hints. tips. tricks
Hyundai Santa FE
Home
 
Hyundai
Santa FE
Operation and maintenance of car
Engine
Maintenance (engines 2,0 / 2,4 l)
Mechanical (engines of 2.0 / 2.4 L).
Cooling system (engines 2,0 / 2,4 l)
Intake and exhaust systems (engines 2,0 / 2,4 l)
Maintenance (2.7 liter engine)
Mechanical (engine displacement of 2.7 liters.)
Cooling system (engines of 2.7 liters)
Tubes and pipes, redundant system cooling
Removing and installing coolant temperature sensor
Removal, check and installation of the water pump (engine V6)
Removal, check and installation of the radiator
Removal, check and installation of the electric motor radiator fan
Check the radiator cap
Removal, check and thermostat installation
Lubrication System (engines of 2.7 liters)
Emission
Fuel system
Tables
Transmission
Chassis
Steering Gear
Brakes
Onboard electric
Body
diagrams
 


Hit Counter by Digits


print page printable version

Removal, check and thermostat installation



Components Thermostat
Fig. 2.310. Components Thermostat



Withdrawal
Drain the coolant so that its level was below the thermostat.
Remove the inlet of the cooling system and the gasket.
Remove the thermostat.

Check

Immersion thermostat water bath
Fig. 2.311. Immersion thermostat water bath


Place the thermostat in hot coolant or water and check that the temperature of the thermostat valve opening corresponds to the nominal value. Replace if necessary (Fig. 2.311).
Valve opening start temperature: 82 ?� C.
Valve opening temperature: 95 ?� C.
The valve stroke (with the full opening): 8.5 mm.

Setting
Check the thermostat valve flange landing in the nest thermostat housing. If the thermostat is not installed properly, it will cover the lower part of the rib in the transfer tube, causing a malfunction of the thermostat.

Securing the transfer tube
Fig. 2.312. Securing the transfer tube


Install outlet pipe with a new gasket (Fig. 2.312).
Tightening torque bolts inlet: 17-20 Nm.
Fill in fresh cooling zhidkost.a




« previos page
Check the radiator cap
next page »
Lubrication System (engines of 2.7 liters)

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.