add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Santa FE (2006 release)
general info. full specifications. diagnostics. hints. tips. tricks
 Hyundai Santa FE
Home
 
Hyundai
Santa FE
Operation and maintenance of car
Engine
Maintenance (engines 2,0 / 2,4 l)
Mechanical (engines of 2.0 / 2.4 L).
Cooling system (engines 2,0 / 2,4 l)
Tubes and pipes, redundant system cooling
Removing and installing coolant temperature sensor
Removal, check and installation of the water pump (engine DOHC)
Removal, check and installation of the radiator
Removal, check and installation of the electric motor radiator fan
Check the radiator cap
Removal, check and thermostat installation
Intake and exhaust systems (engines 2,0 / 2,4 l)
Maintenance (2.7 liter engine)
Mechanical (engine displacement of 2.7 liters.)
Cooling system (engines of 2.7 liters)
Lubrication System (engines of 2.7 liters)
Emission
Fuel system
Tables
Transmission
Chassis
Steering Gear
Brakes
Onboard electric
Body
diagrams
 


Hit Counter by Digits


print page printable version

Removing and installing coolant temperature sensor



Driving install a new O-ring
Fig. 2.154. Driving install a new O-ring



Withdrawal
Drain the coolant below the level of the sensor.
Disconnect the battery and temperature sensor connector

Coolant temperature
Fig. 2.155. Coolant temperature


Remove the sensor (Fig. 2.155).

Setting
Apply thread sealant recommended sensor. Tighten the sensor regulated torque.
Sealant: Three Bond No. Loctite 262 or 1324N.
Tightening torque, coolant temperature: 20-40 Nm.
Connect the temperature sensor.
Connect the battery.
Fill the cooling system.




« previos page
Tubes and pipes, redundant system cooling		 next page »
Removal, check and installation of the water pump (engine DOHC)

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.