printable version
Tubes and pipes, redundant system cooling
Check Check hoses and pipes of the cooling system for cracks, damage, or deposits on their internal walls. Replace if necessary.
Assembly Slide ring seal on the inlet pipe of the cooling system, put on its outer surface a little coolant or water, and then set the tube in place.
NOTE Do not allow the motor oil and grease on the surface of the annular gasket tube cooling system. |
Avoid contact with the junction of the inlet pipe of the cooling system of sand, dust, etc. Insert the inlet pipe in the cooling water pump to stop.
Do not install the washer, the former operation. Replace a new O-ring removed (Fig. 2.154).
|