 printable version
Backdoor
Refitting
| Fig. 7.6. Using a tissue to remove the spring bracket handle window
|
On cars with manual windows, lift the glass and mark the position of the window handle. Remove spring bracket handle window, inserting a piece of cloth between the handle and the door trim and stretching the fabric in one direction or the other opposite ends of the bracket (see. Fig. 7.6). After removing the staples, remove the handle from the window shaft splines.
| Fig. 7.13. Removing the cover of the internal handle of opening of the door lock
|
Unscrew the lid inner door handle and then push the cover towards the door hinge and separate it from the door trim (Fig. 7.13).
| Fig. 7.14. Rear door: 1 - the front side door; 2 - external deltoid molding; 3 - internal deltoid molding; 4 - glass; 5 - rear lower guiding glass; 6 - windows; 7 - electric window; 8 - outer window seal; 9 - an arm; 10 - interior doors; 11 - directing the glass; 12 - Front lower the rear door glass; 13 - pylevlagozaschitnaya film back door; 14 - the outer seal; 15 - molding side rear door seal
|
Remove the three screws that secure the door trim (Fig. 7.14).
| Fig. 7.8. Using a puller (1) to separate the trim from the door
|
Insert puller upholstery or a screwdriver with a wide slot between the door trim and the door, press the door trim (see. Fig. 7.8). Remove an arm of the internal handle and the inside door handle. Remove pylevlagozaschitnuyu film, gradually separating it from the door frame. Lower the door glass and remove the glass run and deltoid bottom groove. Lower door window glass, remove the glass run channel and the division. Tightening torque of fastening of glass - 8-12 Nm; rear window bottom rail - 8-12 Nm. Lower the glass doors and turn out bolts of fastening of glass to the window.
| Fig. 7.11. Removing the glass door
|
Raising while Hatchback glass, clear glass door (see. Fig. 7.11). Remove the nuts and remove the guide window windows assembly. Tightening torque - 4-6 Nm. Remove the lock bolts and remove the lock assembly with rods. Remove the bolts and remove the outside door handle. Remove the rear door side moldings. Installation is spent to sequences, return to removal, taking into account the following. When installing the film seals the door trim butyl tape should not be placed over the area of fastening clamps door trim.
Adjusting the doors Check the alignment of the door with the body, and then check the uniformity of the gap between the front and rear, top and bottom of the door and the body. The gap around the perimeter of the door and between the elements of the body must be uniform.
A WARNING Secure the protective film on the edge of the wing, at the installation site loop. |
Adjusting the shock plate of the door lock Make sure that the door closes easily and straight. If the door is loose, tighten the bolts the door hinges. If necessary, adjust the position of the door relative to adjacent surfaces as follows: - To follow the orientation of the marker circle striking plate of the door lock; - Loosen the screws that secure the shock plate and drag inward or outward to provide a reliable closing of the door, the outer door panel should be flush with the adjacent elements of the body. Slide the shock plate up or down to align with the groove of the castle. Then tighten the screws again and check the reliability of closing the lock and door position.
A WARNING Keep the outside door handle in the "open" position and push the door to the body to align the groove of the door lock with the impact plate. |
Glass doors If the glass does not rise evenly when it is closed, remove the door trim and loosening bolts to the window, adjust the tilt of the glass in the front-rear direction.
| 
