add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 3 (2003 release)

general info. full specifications. diagnostics. hints. tips. tricks
Mazda 3
Home
 
Mazda
3
Operation and maintenance of car
Engine
General description new engines models L8, LF, L3
The mechanical part of engines
Engine Model L8 or LF
Checking the contents of the CO / CH in the exhaust gas
Measurement of engine compression
Verify accessory drive belt
General information and safety when removing the power unit
Removal of sealant
Removal and installation of the power unit
Check actuator variable valve timing (L3)
Removal and installation of the actuator variable valve timing (L3)
Timing chain drive
Preliminary operations
Removing the mounting bolt crankshaft pulley
Removing chain tensioner
Removing the timing chain
Install the timing chain
Install the engine front cover
Install the crankshaft front oil seal
Installing the rubber engine mounts and mounting bracket ?��3 engine ?��3
Installing the mounting bolt crankshaft pulley
Install the cylinder head cover
Removal and installation of the oil control valve (OCV) (L3)
Checking the oil control valve (OCV) (L3)
By operation of the spool valve (OCV) (L3)
General repair operations on the power unit
Check the cylinder head
Assembling the cylinder (the beginning)
Assembling the cylinder (the end)
Assembling the cylinder head
Assembling the valve timing
Appendix 1
Annex 2
Appendix 3
Engine Z6 - mechanical part
Lubrication system
Cooling system
Intake system
Fuel system
Exhaust and Emission
Ignition system
Control system
Tables
Transmission
Chassis
Steering Gear
Brakes
Onboard electric
Body
 


Hit Counter by Digits


print page printable version

Install the cylinder head cover



Places applying sealant
Fig. 2.114. Places applying sealant


Kremnievoorganichesky Apply sealant to the mating surface of the cylinder in the areas shown by the arrows (Fig. 2.114).
The diameter of the point of application - 4.0-6.0 mm.
Install the cylinder head cover with a new gasket.

Order of a tightening of bolts fastening the cylinder head cover
Fig. 2.115. Order of a tightening of bolts fastening the cylinder head cover


Tighten the bolts in the order shown in Figure 2.115, torque 8-11,5 Nm.




« previos page
Installing the mounting bolt crankshaft pulley
next page »
Removal and installation of the oil control valve (OCV) (L3)

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.