REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 3 (2003 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mazda
	3
		Operation and maintenance of car
		Engine
			General description new engines models L8, LF, L3
			The mechanical part of engines
			Appendix 1
			Annex 2
			Appendix 3
			Engine Z6 - mechanical part
			Lubrication system
			Cooling system
			Intake system
			Fuel system
			Exhaust and Emission
			Ignition system
			Control system
				Removing and installing temperature sensor Engine coolant
				Removal and installation of the crankshaft position sensor
				Removing and installing the throttle position sensor
			Tables
		Transmission
		Chassis
		Steering Gear
		Brakes
		Onboard electric
		Body

printable version

Removing and installing the throttle position sensor

Remove the battery cover.

Disconnect the negative battery cable.

Use the following procedure to provide easier access.

Remove the air filter.

Remove the air hose.

Fig. 2.343. Removing the throttle position sensor

Remove the throttle position sensor (Fig. 2.343).

Make sure that the throttle is fully closed.

Set the throttle position sensor on the throttle tube.

Torque: 1.6-2.4 Nm.

Make sure that the throttle valve moves smoothly.

Connect the throttle position sensor.

Make sure that the voltage of the output signal of the throttle position sensor (PID WDS: throttle position) - in the normal range when the valve is open or closed.

If not correct, check the throttle position sensor.

« previos page
Removal and installation of the crankshaft position sensor

next page »
Tables